The hub bearings in your Chevrolet Silverado are used to assist flip the wheels in your car in a clean, fluid motion. Though wheel bearings can final a appreciable variety of years, fixed put on and excessive speeds may cause them to change into worn and broken. If the bearings in your Silverado collapse, they should be changed instantly, as a result of broken bearings can lead to your wheels dropping alignment. Changing broken hub bearings will take you round two hours to finish.
Chevy Silverado 1500 Replace a Hub Bearing Instructions
1. Transfer the car jack beneath the body close to front wheel in your Chevrolet Silverado. Elevate the car off the ground. Place a jack stand beneath the body for added help in case the jack fails.
2. Take away the four lug bolts which repair the wheel onto the axle using a lug wrench. Carry the wheel away from the car. Guarantee you don’t injury the tire.
3. Find the bolts which safe the brake caliper to its bracket. Use a socket wrench to remove the bolts and elevate the caliper out of its bracket. Slide a wire coat hanger via the spring coil on the brake caliper. It will forestall you from handing the brake caliper by the brake line. Hanging the caliper by the brake line will result in damage to the brake line. This may cut back the efficiency of your brakes.
4. Take the rotor off its drive prepare spindle by eradicating the nut from the back of the rotor with the wrench and sliding it away along with your fingers.
5. Find the bolts on the barrel of the wheel hub which safe it to the steering knuckle. Take away the bolts and pull the wheel hub free. Slide the inside and outer bearing seals from the wheel hub.
6. Open up the seals and remove the previous bearings. Discard the bearings. Use a dry material to wipe away all the previous grease from contained in the seals. Coat the brand new bearings in grease and place them into the seals. Close the seals and slide them back into the wheel hub. Reattach the wheel hub by securing the mounting bolts to connect it to the steering knuckle.
7. Replace the rotor back on the spindle and reattach the retaining nut. Take away the wire from the brake caliper coil and slide it back into the bracket. Safe it with the mounting bolts. Place the wheel on the axle and reattach the lug nuts with a lug wrench. Repeat the process on the rest of the wheels.
Read more : How to Replace a Hub Bearing in a Silverado 1500
